SN74ABTH162460DL

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The SN74ABTH162460DL is a 3-state 16-bit wide bus transceiver with 3-state outputs and Schmitt-triggered inputs. It is ideally suited for implementing data communications and can be used for a variety of applications like motor control system, digital logic circuit, serial communications, and DSP data transfer. The SN74ABTH162460DL belongs to the family of Logic - Signal Switches, Multiplexers, Decoders.

The SN74ABTH162460DL is used to isolate two independent buses while allowing them to communicate with each other to create bidirectional data flow between them. This transceiver can also be used to transfer data within a single bus. It consists of eight transceiver units with two control signals, A and B. When the A control signal is asserted, data is transferred from the A bus to the B bus, and when the B control signal is asserted, data is transferred from the B bus to the A bus. The SN74ABTH162460DL has two enable signals, OEn and IEn, which are used to enable or disable the transceiver.

The SN74ABTH162460DL has a 16-bit wide data bus and two enable lines. Data is transferred four bits at a time and the enable lines perform data enable operations in order to prevent valid data from being overwritten by invalid data. The SN74ABTH162460DL also contains a Schmitt trigger in its input to provide additional noise immunity. Moreover, the SN74ABTH162460DL can be used in asynchronous data transfer applications where data is clocked through a single bus but only one bus at a time.

The SN74ABTH162460DL has two active-low control signals, A and B, which are used to switch between the two buses in a bidirectional manner. When the A signal is asserted, the transceiver will transfer data from the A bus to the B bus. When the B signal is asserted, the transceiver will transfer data from the B bus to the A bus. The SN74ABTH162460DL also contains two enable lines, OEn and IEn. These two lines are used to enable or disable the transceiver in two different directions, respectively. OEn is used to enable/disable the output from the A bus to the B bus, while IEn is used to enable/disable the input from the B bus to the A bus.

The SN74ABTH162460DL is used in various applications such as digital logic, motor control system, serial communications, and DSP data transfer. The transceiver can be integrated into synchronous communication applications where it allows data to pass through a single bus but only one at a time. The SN74ABTH162460DL is suitable for embedded systems that require a low cost, high speed data transfer solution. The SN74ABTH162460DL also allows for multiplexing of data signals with two channels, which can be used in applications where two buses are required to communicate simultaneously.

In conclusion, the SN74ABTH162460DL is a 3-state 16-bit wide bus transceiver that is ideal for implementing data communications. The transceiver is used in a variety of applications such as digital logic, motor control system, serial communications, and DSP data transfer. It is classified in the family of Logic - Signal Switches, Multiplexers, Decoders, and is suitable for embedded applications that require a low cost, high speed data transfer solution. The SN74ABTH162460DL is a reliable and cost effective transceiver which provides low power consumption.

The specific data is subject to PDF, and the above content is for reference