SN74ALS191ADG4

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The SN74ALS191ADG4 integrated circuit is a 4-bit asynchronous binary counter that is part of the Logic - Counters, Dividers family. This counter uses two basic types of inputs: Clock and Reset. When a Clock input is high, the next clock cycle will increment the count. The Reset input resets the counter back to zero, allowing the user to start the count from a known state. The Clock and Reset inputs have internal pull-up resistors that can be enabled with the RST EN (Reset Enable) and CLK EN (Clock Enable) pins. This device also features an asynchronous carry output which can be used to cascade multiple counters and produce higher order counts.

The SN74ALS191ADG4 counter is a typical 4-bit synchronous binary counter. It works by taking a clock pulse on the clock input pin and incrementing the count by one. This count is represented by the state of four output pins, which can be connected to external circuitry to interpret the count. For example, if four LEDs are connected to the count pins, then when the clock is pulsed, the LEDs will shift from one state to the next. The Reset input controls the counter\'s state. When the Reset input is set high, the counter will reset to all zeroes, and start the count from zero again when the clock is pulsed. This allows the counter to begin from a known state each time it is triggered.

The SN74ALS191ADG4 counter can also be used to produce higher order counts by cascading multiple counters. This is accomplished by connecting the carry output of one counter to the clock input of the next counter in the chain. This creates a “ripple carry” effect so that when one counter reaches its maximum count, it will cause the next counter in the chain to increment its count. This can be repeated to create higher order counts at higher frequencies.

In addition to its counter capabilities, the SN74ALS191ADG4 also has divide-by-N capability which is controlled by the Mode Select (MS) input. When this pin is set low, it will divide the incoming frequency by 2N (where N is the number of bits in the counter). This is useful for applications where a slower clock signal is needed such as generating slow pulse width modulation (PWM) signals.

The SN74ALS191ADG4 is a versatile counter with a wide range of applications. It can be used in digital clocks and timers, frequency dividers, counter-based data loggers, and various types of oscillators. It is also well-suited for embedded systems where its small size and low power consumption are beneficial. The counter is capable of high-speed operation and can be used in a variety of applications where a controlled clock signal is required.

The specific data is subject to PDF, and the above content is for reference