SN74CB3T3245PWE4

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Logic - Signal Switches, Multiplexers and Decoders are important components in digital and analog technology, and the SN74CB3T3245PWE4 has played a major role in improving this technology. The SN74CB3T3245PWE4 is a high performance octal bus transceiver from Texas Instruments. It is a dual non-inverting buffer/driver designed for 2-wire bidirectional data transmission between registers. This buffer/driver is designed with four sets of four data paths, each in an independent bus, thus providing four-bit isolation between the buses.

The SN74CB3T3245PWE4 is suitable for both high-speed as well as slow-speed applications. It has low power supply current, high output current and low propagation delays. This is why the SN74CB3T3245PWE4 is considered suitable for communication and data transfer applications. It is also suitable for applications such as medical, automotive, wireless and consumer electronic products. The SN74CB3T3245PWE4 is also an appropriate for digital systems where power savings is essential as it has a low quiescent power consumption.

The SN74CB3T3245PWE4 has a working principle of dual non-inverting buffer/driver. According to this principle, the device is designed to accept eight TxD inputs and eight RxD inputs and each of the inputs having the corresponding output at the same time. The TxD pins are open-drain type outputs, which can be used to drive a variety of external loads. Each TxD output can be connected to one of two levels, either high or low and the connected RxD output will be driven according to the current level of the TxD output. The RxD outputs can also be connected to either a high-impedance level or a low-impedance level, depending on the enabled state of the E-pins. The 2-wire bus signals are auto-directional, allowing for bidirectional data transfer between registers.

The SN74CB3T3245PWE4 is also equipped with an output enable pin which can be used to disable the device or enable it in a low-power mode. The device is enabled by the active-low E-pin which is connected to the ground line. When low, the device is enabled and the input signals are accepted; however, when the pin is not connected to the ground line, the device is disabled and the input signal is not accepted. Additionally, the device also contains an inhibit pin which can be connected to either the GND pin or the VDD pin to disable the device.

Due to its low power consumption, broad operating speed, and fast switching speed, the SN74CB3T3245PWE4 is ideal for low power applications, such as medical, automotive, wireless and consumer electronic products. Additionally, its wide range of output enables and breaks makes it suitable for communication and data transfer applications. The SN74CB3T3245PWE4 is also extremely reliable and its low cost makes it a great choice for both industrial and consumer applications.

The specific data is subject to PDF, and the above content is for reference