X9C503PZ

Memory Type:	Non-Volatile
Base Part Number:	X9C503
Supplier Device Package:	8-PDIP
Package / Case:	8-DIP (0.300", 7.62mm)
Operating Temperature:	0°C ~ 70°C
Resistance - Wiper (Ohms) (Typ):	40
Temperature Coefficient (Typ):	±300 ppm/°C
Tolerance:	±20%
Features:	--
Voltage - Supply:	5V
Series:	XDCP™
Interface:	Up/Down (U/D, INC, CS)
Resistance (Ohms):	50k
Number of Taps:	100
Number of Circuits:	1
Configuration:	Potentiometer
Taper:	Linear
Part Status:	Active
Packaging:	Tube

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

X9C503PZ is a digital potentiometer, which is a data acquisition device and a programmable resistor used to create an adjustable voltage divider. It provides a precise control of resistance values that are programmed with digital commands. The device is primarily used in applications where precise, digital control of resistance is needed.The X9C503PZ is an 8-bit, volatile digital potentiometer with a wide adjustment range of 1K to 5K ohms. It features a write strobe to initiate program changes, a protection circuit to prevent programming with exceeding voltage and an active LOW chip select line. It also has a resistive element resolution of 32 steps with a down scaler of 1/128, allowing for fine adjustments and a total resistance range of up to 4K ohms, which makes the device ideal for precision applications.The X9C503PZ is controlled using the pulse-width encoded serial Interface (SIP) protocol that sends eight pieces of data to be stored in an internal latch. This data is then transferred to the correct register, where it is used to program the device’s resistive element and output ports. The device can be programmed in one of two ways: either by a serial data line or by a three-wire serial control line. The serial data line is used to transfer data in order to set the output ports while the control line is used to send a command and to initiate a write operation. Both serial interfaces use the same command definitions.The X9C503PZ is suitable for a wide range of applications, including voltage divider circuits, feedback networks, precision amplifiers, digital-to-analog converters and switch circuits. It is also used in filter networks, potentiometric transducers, pulse-generator circuits and power supplies.The X9C503PZ works by adjusting the resistance of a wiper element between two manual pins. The device contains a Nonvolatile Memory (NVM) block, which stores the control data sent via the serial or control lines. When data is sent via the serial interface, it is stored in the NVM block and then transferred to an internal register. This internal register is what controls the actual resistance value of the wiper element.The X9C503PZ is an ideal device for a range of data acquisition applications, providing precise digital control of resistor values. It is cost effective, easy to use, and requires no external programming. Its small form factor and versatile range of features make it a great choice for a variety of applications.

The specific data is subject to PDF, and the above content is for reference

Part Number	Manufacturer	Price	Quantity	Description