CDBJFSC8650-G

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The CDBJFSC8650-G is a single rectifier diode that has a variety of applications and features. It has a nominal forward current of 150mA, a maximum surge current of 800mA, a reverse voltage of 55V, and a reverse recovery time of 100ns. This diode can be used for general-purpose rectification in power supplies and power converters, as well as for high frequency rectification in other digital circuits. In addition, the CDBJFSC8650-G is suitable for use in switching mode applications, such as switch-mode power supplies and DC/DC converters.

The working principle of a rectifier diode is based on the P-N junction that is created when two types of semiconductor material are brought in contact which allows current to flow in one direction but not in the other. When forward biased, the diode acts as a closed switch and allows current to pass through it. When reverse biased, a very small amount of current is able to pass through the diode, known as reverse current. In the case of the CDBJFSC8650-G, the diode is rated for a maximum reverse voltage of 55V and a forward current of 150mA.

The CDBJFSC8650-G is also useful for rectifying AC signals; this process is known as half-wave rectification. With AC voltage, in each alternate half-cycle, the voltage changes direction. During the half-cycle where the magnitude of the voltage is greater than the diode\'s reverse breakdown voltage the diode will conduct current, and during the other half-cycle the diode will just block the current flow. This rectified signal will only contain half of the original frequencies of AC signals, resulting in a signal with a lower frequency than the original AC signal.

The CDBJFSC8650-G can also be used for full-wave rectification of AC signals. This process requires the use of two diodes in a bridge configuration. During the positive and negative half-cycle, each diode will alternate between conducting and blocking the current. This will result in two positive pulses of the same amplitude that are 180 degrees out of phase with each other. This rectified signal will contain both the original frequencies of the AC signal, as well as their harmonics.

The CDBJFSC8650-G can also be used as a switch to regulate current in DC circuits. When connected with the circuit, the diode will act as a closed switch until the voltage across it exceeds the reverse breakdown voltage. Then, the diode will become an open switch and will not allow current to flow through. This effectively acts as a switch that can be used to turn a circuit on and off.

The CDBJFSC8650-G can also be used in voltage clamping applications. As a voltage is applied across the diode, the voltage across the diode will start to increase. If the applied voltage exceeds the reverse breakdown voltage, the diode will start to conduct current, and this will result in the diode\'s voltage drop across the diode to start dropping until the current flow through the diode reduces to a minimum. This process acts as a voltage limiter by limiting the applied voltage from exceeding a certain value.

In conclusion, the CDBJFSC8650-G is a versatile single rectifier diode that can be used in a variety of applications including power supplies, high frequency rectification and switching, half-wave and full-wave AC signal rectification, as a switch in DC circuits, and in voltage clamping application.

The specific data is subject to PDF, and the above content is for reference