LT6015HS5#TRPBF

Due to market price fluctuations,if you need to purchase or consult the price.You can contact us or emial to us:   sales@allicdata.com

1. Describe

The LT6015HS5#TRPBF is a single/dual/quad rail-to-rail input op amp with input offset voltage trimmed to less than 50µV. Operating from single and split supplies, these amplifiers operate from 3V to 50V total and consume only 315µA per amplifier. They have reverse battery protection and draw very little current in reverse supplying up to 50V. The Over-The-Top® input stage of the LT6015/LT6016/LT6017 is designed to provide additional protection in harsh environments. The input common-mode range extends from V– to V+ and beyond: the input voltage of these amplifiers can be up to 76V above V– independent of V+. Internal resistors protect the input from transient faults up to 25V below the negative supply. The LT6015/LT6016/LT6017 can drive loads up to 25mA and are unity-gain stable with capacitive loads up to 200pF. Optional external compensation can be added to extend the capacitive drive capability beyond 200pF. The LT6015 is available in a 5-pin SOT package. The LT6016 dual op amp is available in an 8-lead MSOP package. The LT6017 is available in a 22-pin leadless DFN package.

2. Feature

    1. Input common mode range: V– to V– + 76V

    2. rail-to-rail inputs and outputs

    3. Low power consumption: 315μA/amplifier

    4. Operating temperature range: –55°C to 150°C

    5. VOS: ±50μV (max)

    6. Common mode rejection ratio, PSRR: 126dB

    7. Battery reverse protection to 50V

    8. Gain bandwidth product: 3.2MHz

    9. Specified on 5V and ±15V supplies

  10. High voltage gain: 1000V/mV

  11. no inversion

  12. No power sequencing problem

  13. Single 5-Lead SOT-23 (ThinSOT™) Package

  14. Dual 8-pin MSOP

  15. Quad 22-pin DFN (6mm × 3mm)

3. Application

    1. High-side or low-side current sensing

    2. Battery/Power Monitoring

    3. 4mA to 20mA transmitter

    4. High voltage data acquisition

    5. Batteries/Portable Instruments

4. Pin configuration

5. Application Information

There are two main sources of op amp distortion: Output crossover distortion as output transform from source to sink current and distortion caused by through nonlinear common-mode rejection. If the op amp is Operates in an inverting configuration without common mode induced distortion. If the op amp is running Non-inverting configuration within normal input Common Mode Range (V– to V+ –1.5V) CMRR Very Good, usually over 120dB. When the LT6015/LT6016/The LT6017 converts the input stage from normal input stage to Over-The-Top input stage and vice versa, Since linearity will drop significantly Changes in the input circuit. Lower load resistance increases distortion due to network Reduced loop gain and greater internal voltage swing to the amplifier needed to drive the load, but to Input stage transition distortion. lowest distortion Can be purchased with LT6015/LT6016/LT6017 In Class A operation in an inverting configuration, with Enter the middle between the common-mode bias supplies.