MBRH12035R

The MBRH12035R is a type of single rectifier diode. It belongs to the category of diodes, which are widely used in the electronics industry. This diode is widely used in rectifier applications, because of its high frequency, low noise characteristics.

A diode is a two-terminal device that allows current to flow in one direction only. The MBRH12035R is a single-phase rectifier diode, with an average forward voltage of 1.2 volts, a breakover voltage of 35 volts, and a maximum reverse current of 0.2 amps. Its maximum peak forward current is 35 amps, with a power rating of 500 watts. Its reverse recovery time is in the nanosecond range, allowing for high efficiency.

The MBRH12035R has a wide range of applications in the electronics industry. It is mainly used for rectifier applications, where it acts as a voltage regulator. It can convert alternating current (AC) into direct current (DC), or vice versa. This diode is widely used in power supplies and switching circuits, due to its high efficiency and low noise characteristics.

The MBRH12035R also has a wide range of applications in power semiconductors. It can be used in switching modes to control the current flow, as well as to provide protection against transients. In this field, the diode increases the efficiency in different types of circuits, such as power factor correction, and motor control.

The working principle of the MBRH12035R is quite straightforward. When a voltage is applied between the diode\'s terminals, the diode will start conducting, allowing current to flow in the forward direction. The current will continue to flow until the applied voltage drops below the breakdown voltage. When the voltage drops below the breakdown voltage, the diode will stop conducting, effectively blocking the current from flowing in the reverse direction.

In conclusion, the MBRH12035R is a type of single-phase rectifier diode, with a wide range of applications in the electronics industry. Its maximum peak forward current is 35 amps, with a power rating of 500 watts. Its reverse recovery time is in the nanosecond range, allowing for high efficiency. It is mainly used for rectifier applications, due to its high frequency, low noise characteristics.