PC357N4TJ00F

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Optoisolators are electronic components which are used in sensing and controlling circuits to provide electrical isolation between circuits. The PC357N4TJ00F is a 4-Pin Transistor, Photovoltaic Output Optoisolator.

When it comes to applications, the PC357N4TJ00F finds wide use in safety circuits, alarm circuits, remote sensing, low-current sensing, and frequency counting. It also has applications in controlling outputs such as relays, LEDs, and motors. This small, insulated, bipolar device can safely and conveniently transfer data across separations.

With the PC357N4TJ00F optoisolator, a circuit on the low side operates with just a few milliwatts and requires a low-current on/off input. On the other side, it isolates a higher voltage and can typically control a few amps at up to 30 volts. The 4-pin photovoltaic output optoisolator also features a lower current transfer ratio. This allows a higher level of isolation, well beyond that which is provided by standard optoisolators.

In terms of features, the PC357N4TJ00F has a guaranteed CTR (Current Transfer Ratio) of 200% minimum, and a power dissipation of 5W. Its VCE (Collector-Emitter Voltage) is 50V and IC rating is 80mA. Its response time is 20 microseconds (min) and its breakdown voltage is 70V.

The way the PC357N4TJ00F works is quite straightforward. The optoisolator contains two components – an optically isolated LED and a phototransistor, which are electrically insulated from each other. The LED is turned on when a voltage is applied to the Anode. This sends a light signal through the transparent section of the optoisolator. When the light reaches the phototransistor, a current starts flowing through the optoisolator. The amount of current is limited, which limits the power flowing between the two components.

The Signal Diagram of the PC357N4TJ00F shows how the voltage is used to trigger the LED, and the LED then triggers the phototransistor. The trigger voltage can be an analog or digital signal, depending on the requirements of the application. The output of the optoisolator is usually a much higher voltage, depending on the optoisolator, which is why they are commonly used to isolate hazardous voltages.

The PC357N4TJ00F optoisolator is a versatile component which is capable of providing significant levels of isolation, without consuming a lot of power. Its small size and wide range of features make it ideal for a wide range of sensing and controlling applications, such as safety circuits, remote sensing, and low-current sensing.

The specific data is subject to PDF, and the above content is for reference