PCF8575CDWE4

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The PCF8575CDWE4 is an I/O expander integrated circuit providing 16 bi-directional (bidirectional) I/O lines. PCF8575 is well known as a programmable I/O (GPIO) expander chip, and is widely used in many electronics projects to expand the number of GPIO lines available. PCF8575 is a NXP (formerly Philips) brand name, and is available in both 8-bit and 16-bit versions.

This article introduces the application fields and working principle of PCF8575CDWE4.

Application Fields

The PCF8575CDWE4 is a 16-bit I/O expander with an integrated I2C bus interface. It can be used in various applications, such as Raspberry Pi, Arduino-based projects, etc. It is also used in system design projects where more I/O lines are required for control, alarms, digital-to-analog and analog-to-digital conversions, monitoring, etc. It can be used with microcontrollers, microprocessors, and various communication devices.

The PCF8575CDWE is also used in embedded systems as a bus expander to connect multiple devices, such as EEPROMs and serial memories, over short distances. It can be used in combination with an I2C-bus multiplexer, allowing an I2C-bus master to control multiple I2C-bus slave devices.

The PCF8575CDWE is also used in control systems and electronic projects, such as UPS systems, automatic water level controllers, and smart home automation systems.

Working Principle

The PCF8575CDWE uses an I2C interface to communicate with the host microcontroller or processor. It operates in two modes: master mode and slave mode. In master mode, it acts as an I2C-bus master, sending data and control signals to other I2C devices. In slave mode, it listens for commands from an I2C-bus master.

The PCF8575CDWE has four Group Enable (GEn) outputs, which are used to individually enable four groups of four I/O lines. When enabled, the I/O lines are driven by PCF8575CDWE and can be used as inputs or outputs. When disabled, the I/O lines are tri-stated and can be used as inputs or outputs by other devices.

The PCF8575CDWE can be used to read and write 8-bit, 16-bit, or 24-bit data words over the I2C-bus. It supports both the standard I2C-bus protocol, as well as a unique 3-wire protocol. The 3-wire protocol is used to access the data register of PCF8575s, allowing direct access without bus arbitration.

The PCF8575CDWE has seven pins for system interfacing. It has two power pins (VCC and GND), two clock pins (SCL and SA), two data pins (SDA and SD), and one Reset pin. It has an operating voltage range of 2.5V to 5.5V, and a maximum output current of 200mA.

The PCF8575CDWE has a low-power Sleep mode, allowing for power saving when the device is not in use. It also has an interrupt facility, which can be used to generate interrupts when input levels or status registers change.

The PCF8575CDWE also has 16 address pins, allowing it to respond to up to 16 different I2C-bus addresses. This allows multiple PCF8575s to be connected to the same I2C-bus and individually addressed.

The PCF8575CDWE is a versatile I/O expander that can be used in a variety of applications. It has a low-power Sleep mode, an interrupt facility, and 16 individually addressable I/O lines. It can be used to expand the number of I/O lines available for applications such as microcontroller-based projects, embedded systems, control systems, and alarm systems.

The specific data is subject to PDF, and the above content is for reference