EGP20D-E3/54

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

EGP20D-E3/54 is a single-phase highly integrated rectifier diode, also known as a half-wave rectifier. It is a three-pin package, with the anode, cathode, and a mounting tab denoted as G, A, and K, respectively. Through properly wiring, EGP20D-E3/54 is suitable for general rectification under 200V direct current sourcing scenarios, with reverse voltage ratings up to 1500V. It has a comparatively low forward voltage drop of 0.8V, and a maximum reverse current rating of 50uA. With these features, it is suitable for use in a variety of switching power supplies and ultrafast rectifying applications.

When submitted to a reverse bias voltage, the EGP20D-E3/54 will not conduct. This is due to a very high resistance between the anode and cathode acting as a \'valve\' and blocking current flow. Under a forward bias, the diode behaves more like a conductor, with a predefined voltage drop (Vf) used to power the device. This results in conduction between the cathode and anode, allowing for the rectification of an incoming AC signal.

The EGP20D-E3/54 finds usage in numerous power conversion systems in some form. It is very commonly used in flyback converters and AC/DC power supplies, due to its low forward voltage drop and fast switching time, leading to a reduction in power consumption. EGP20D-E3/54 is also used in switching power supplies and motor control applications. In soft switching circuits, it can be used in place of a diode bridge due to its low voltage drop and reverse recovery time. In other circuits such as solid state relay drivers, the diode is used to protect the circuit from power surges due to ringing. It is also used in clamping applications, where it is wired across certain portions of a circuit.

The EGP20D-E3/54 is relatively easy to use and install, due to its three-pin package and intuitive wiring. The anode pin is wired to the source, while the cathode is wired to the device load. The mounting tab is either wired to the chassis to dissipate heat, or connected to the ground. It is important to note that all wiring should be done according to rated values, and that the device must be installed in a manner that does not interfere with its thermal performance.

In conclusion, the EGP20D-E3/54 is a highly reliable and efficient single-phase rectifier diode, designed and optimized for the rectification of 200V DC signals. It is relatively easy to use and install, with a low forward voltage and fast switching times. Its low reverse leakage current and high reverse voltage ratings make it suitable for a variety of applications in power conversion and protection. As such, it is an excellent choice for any rectification and thermal protection needs.

The specific data is subject to PDF, and the above content is for reference