ISL43L420IR-T

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

ISL43L420IR-T is an integrated component designed and manufactured by Renesas Electronics specifically designed for use in the interface of analog switches and multiplexers of electronic circuit systems. It is a single package component containing two identical 4-channel multiplexers and four 2-channel analog switches.

The component has a wide range of applications, including switching between a power supply and input signal, selecting an input signal from parallel multiple signals and feeding it to a data output and control circuit, providing better acoustic fidelity control in audio system and facilitating the conversion of cryptographic signals. It is also used to implement channel routing between switches or amplifiers by controlling each switch channel in a multiplexer.

The ISL43L420IR-T comes with an 8-bit control interface, which uses two voltage-level control lines (V1, V2) and a reset line (RST). Voltages V1 and V2 are used to control the multiplexers, while the RST line is used to reset the analog switches and multiplexers following each instruction. The component also has four logic lines (D1, D2, D3 and D4), which are used to select the desired circuit chain from up to 16 combinations.

The working principle of ISL43L420IR-T is based on narrowing a circuit chain of voltages and currents to the desired paths. In order to achieve this, the component uses a control port interface to enable voltage and current selection. When first powered, the component’s multiplexers and analog switches will select the default path, which is usually configured to the desired value when the device is in the factory. From this point onwards, the voltage level and logic line values of the two control ports can be used to select desired paths.

In order to select a certain path, the control port will send a combination of control signals to the multiplexers and analog switches. The multiplexers select the desired path by comparing the signals sent to them through the two control lines: V1 and V2. The signals sent to the analog switches represent the paths that need to be enabled, whilst the RST line must always be 0 in order to avoid unnecessary switching. The logic lines then provide the multiplexer with the selection instructions, thus allowing for an up to 16 combinations of the multiplexer.

ISL43L420IR-T is an advanced component, which greatly enhances the analog switch and multiplexer capabilities of electronic circuit systems. Its 8-bit control interface, as well as its programmable switching capabilities, makes it one of the most advanced devices of its kind in the market today.

The specific data is subject to PDF, and the above content is for reference