MNR04MRAPJ513

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

MNR04MRAPJ513 is an electronic component belonging to the resistor networks, arrays category. Resistor networks are arrays of resistors whose purpose is to provide lumped element impedance for matching, filtering, switching and voltage division. The MNR04MRAPJ513, in particular, is a 4 terminal array for filtering and switching purposes.

It comprises 16 resistors arranged in a square network in which each resistor is connected to its neighbour. The resistors are constructed as thin-film, possibly of ceramic dielectric, and are connected together using bonding wires, vias and lateral connections. Each resistor has an individual value, which is specified by the manufacturer and cannot be changed as is the case for conventional resistors. The network\'s four terminals allow the resistors to be connected in a variety of ways - as a low-pass filter, band-pass filter, high-pass filter or a switch of any value. Moreover, the resistance between the different terminals can be changed in situ for fine-tuning the behaviour of the network.

Basically, MNR04MRAPJ513 is used for crosstalk isolation, where the network is connected between the input and output lines in such a way that the input signal is filtered and leakage of signals to the output lines is reduced. Alternatively, MNR04MRAPJ513 can be used as a switch to route current in a desired path when a certain voltage threshold is exceeded, as in the case of logic gates.

The operating behavior of MNR04MRAPJ513, which is dictated by its resistor values, is determined by its basic open-circuit 4-terminal admittance matrix. This is calculated by measuring the resistances between the four terminals. With this information, an open-circuit admittance matrix is derived (Yoc - i.e. four measured admittances at open-circuit conditions) which provides both the location and value of the resistors.

MNR04MRAPJ513 can be also used for filtering purposes. Generally, the filter is divided into two parts. The first part consists of two resistor and capacitor components connected in a T-section, while in the second part, two resistor and capacitor components are connected in a low-pass configuration. Usually, this filter is used to reduce the effect of noise in analog circuits. More specifically, it is used as a low-pass filter to reduce noise commonly found in communication systems.

In conclusion, MNR04MRAPJ513 is an extremely versatile component used in a variety of applications related to filtering, switching and crosstalk isolation. Its operating behaviour is determined by the resistor values embedded in the circuit, which can be determined through the open-circuit admittance matrix. Thus, it is widely used as a low-pass filter to reduce noise commonly found in communication systems.

The specific data is subject to PDF, and the above content is for reference