NCP553SQ18T1

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

NCP553SQ18T1 is an advanced 3- terminal adjustable low dropout voltage regulator with a current limit of up to 2 A. The IC requires no external component and provides a thermal monitoring output for over temperature protection. It is specially designed for powering systems with high current loads. Thanks to its low dropout voltage, it offers a wide range of output voltage adjustments and also enables the use of low ESR output capacitors.

The NCP553SQ18T1 can be classified under PMIC – Voltage Regulators – Linear. It is usually used in applications such as notebook and desktop PCs, workstations, gaming consoles, set-top boxes, automotive and Motor Control, consumer audio and video, LED backlighting and industrial control equipment.

The NCP553SQ18T1 has three terminals. It consists of a P-type MOSFET (internal power transistor) with two external input/output terminals, GND (ground) and VOUT (output voltage), and one adjustable output voltage terminal, ADJ (adjust). It also has an enable pin for driving the internal MOSFET.

The NCP553SQ18T1 can operate from an input voltage range of 4.5 V to 36 V with an adjustable output voltage range from 0.6 V to 4.7 V (according to the part number). It can deliver up to 2 A of continuous output current, depending on the ambient temperature and the input/output voltage differential. The typical dropout voltage of the IC is 0.3 V at full load.

The operating principle of the NCP553SQ18T1 is simple. It works by using the voltage differential between the input and output terminals to control the output voltage. It does this by using its built-in P-type MOSFET, which acts as a low pass filter. The output voltage is controlled by the ADJ terminal, which is a resistor divider from the input voltage. The voltage at this terminal is compared to a reference voltage, which is internally generated. When the voltage at the ADJ terminal is higher than the reference voltage, the internal MOSFET is turned off, thus diverting current away from the output voltage and therefore reducing the output voltage. When the voltage at the ADJ terminal is lower than the reference voltage, the MOSFET is turned on, thus allowing current to flow into the output voltage and thus increasing the output voltage.

The NCP553SQ18T1 offers several additional features to further improve the performance and reliability of the voltage regulator. It has an over temperature protection feature that reduces the output voltage when the internal temperature of the IC exceeds a certain threshold. It also has thermal monitoring output that can be used to indicate when there is an over temperature condition. And it has a current limit circuit that reduces the output current when it exceeds a certain limit, thus protecting the IC from being over current.

The specific data is subject to PDF, and the above content is for reference