SKY66002-11

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

RF Amplifiers are electronic components that have the ability to increase the voltage or power of a signal while preserving its wave shape. The SKY66002-11 is a radio frequency (RF) amplifier specifically designed for mobile and wireless communication systems. It is a monolithic low noise power amplifier for use in the 1327 to 1517 MHz UHF frequency band. This module offers high gain, low noise and low power consumption, as well as being both highly linear and broadband.

The SKY66002-11 is a three-stage LNA (Low Noise Amplifier) amplifier based on a enhanced Crest amplifier design. It is made using an advanced 0.13um CMOS process. It has good linearity across the whole frequency range due to its high gain, low noise figure and high OIP3 (Output IP3). The amplifier is also well matched to 50ohm load impedance, with low return loss and a good input return loss.

The SKY66002-11 is designed for use in a wide variety of applications, such as WiLinx base transceiver station (BTS), wireless local area network (WLAN) and broadband access. It can handle both downlink and uplink signals from the antenna. The high linearity and high gain makes it suitable for applications that require a large dynamic range. It is also suitable for applications that require high levels of sensitivity, such as for GPS receivers or tracking systems.

The SKY66002-11 has an input voltage range of 0.2-4.1V DC and a typical noise figure of 4.3dB. It has a gain of greater than 20dB and a noise figure of less than 0.5dB over the entire frequency range. The amplifier also has a high output third-order intercept point of greater than 20dBm over the frequency range from 1327 to 1517MHz.

The SKY66002-11 uses an advanced circuit topology which provides a low power consumption and high efficiency. It has a power-down mode that can shut down the circuit when it is not in use. This power-down mode can also be externally triggered, allowing the SKY66002-11 to be used in applications where power saving is important. The amplifier is also self-biased and can be used without an external bias supply.

The working principle of the SKY66002-11 is based on the concept of a cascade amplifier. A signal is applied to the first stage where it is amplified by an amplifier. The signal then passes to the second stage where it is further amplified. This process is repeated until a desired level of gain is achieved.

The SKY66002-11 is easy to use and has a wide range of applications. It is a reliable and efficient solution for those looking for a low-cost RF amplifier for their mobile communication systems. It is an ideal solution for applications that require a high dynamic range and high sensitivity.

The specific data is subject to PDF, and the above content is for reference