1PGSMC5348 R7G

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

A 1PGSMC5348 R7G diode is a type of single Zener diode that finds many applications in circuitry. The device is primarily used for voltage regulation and for protecting other components from overvoltage, and it is also used in circuit protection and overvoltage fault isolation.

1PGSMC5348 R7G diodes are rated at 5.6 volts. This means that they will start to conduct current if the voltage on either side of the diode exceeds 5.6V, and the diode will direct current from the higher-voltage side to the lower-voltage side. A resistor may be used in series with the diode to limit current through the device, to prevent damage. The diodes are available in a range of variants, including the 1PGSMC5348S and 1PGSMC5348S+, with different maximum power and current ratings.

The 1PGSMC5348 R7G finds applications in many areas, including voltage regulation, circuit protection and overvoltage fault isolation. It is used to protect components from overvoltage, which can occur due to electrical surges, voltage spikes, or other transient electrical phenomena. The diode will allow current to pass in one direction only, and will direct this current away from components and towards ground, preventing damage due to overvoltage.

The major working principle of 1PGSMC5348 R7G diodes is based on a PN junction diode. As the voltage across the diode exceeds the Zener voltage, the diode starts conducting current. When this occurs, the current will be directed away from the higher-voltage side towards the lower-voltage side, ie towards ground. The reverse bias voltage needs to be greater than the Zener voltage for the device to conduct. This ensures that the device will remain off until the Zener voltage is exceeded, thus preventing damage to the components from overvoltage.

1PGSMC5348 R7G diodes are used in many different applications, from overvoltage protection and circuit protection to voltage regulation. They are used to protect components from overvoltage, and to direct current away from the higher-voltage side and towards ground. The device works by blocking current flow until the Zener voltage is exceeded, at which point it will conduct. By using the device in a circuit, it is possible to prevent damage due to overvoltage, while also providing voltage regulation.

The specific data is subject to PDF, and the above content is for reference