IP4253CZ12-6,118 Filters

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The IP4253CZ12-6,118 is an EMI/RFI filter that utilizes a combination of inductive and capacitive components to filter out unwanted electromagnetic interference (EMI) and radio frequency interference (RFI) from electrical signals. The filter is used to ensure that data being transferred over wires or copper traces is clean and not distorted by unwanted interference. It is commonly used in applications including automotive, medical, industrial and instrumentation control systems.

The device is composed of a three-terminal inductor or coil, one capacitor and a resistor. The inductor is usually rated at 6-6.8 µH of inductance, while the capacitor is rated at 0.047-0.059 µF of capacitance. The resistors are normally rated at 118 ohms. The filter operates on the principle that the inductor-capacitor network forms a tuned circuit which is designed to attenuate the frequency components in a signal that are outside the desired range.

When a signal is applied to the input port, the filter attenuates the higher frequency components which are outside the desired frequency range. This is done by creating an impedance that is inductive at high frequencies and capacitive at low frequencies. This impedance effectively "shunts" the higher frequency components and allows them to pass through the filter and be dissipated as heat. The filter also blocks signals from entering the electronic device that are outside of the desired frequency range.

The filter is typically mounted on a circuit board and connected to the input and output ports of the device it is protecting. The filter is also designed to be not too restrictive, so that signals within the desired frequency range can pass through with little or no degradation. The filter can also help prevent unwanted currents from entering the circuit board, which can cause malfunctioning and damage.

In summary, the IP4253CZ12-6,118 is an EMI/RFI filter used to ensure that data being transferred over wires or copper traces is clean and not distorted by unwanted interference. The device is composed of a three-terminal inductor or coil, one capacitor and a resistor and operates by attenuating the higher frequency components which are outside the desired frequency range. The filter is typically mounted on a circuit board and connected to the input and output ports of the device it is protecting so that signals within the desired frequency range can pass through with little or no degradation.

The specific data is subject to PDF, and the above content is for reference