V10P20-M3/87A

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The V10P20-M3/87A rectifier is a single phase, silicon based, three-pin bridge rectifier that is capable of delivering up to 10A continuous forward current (I_F max) and 20A peak forward surge current (I_FSM max). It was designed for use in AC-DC rectification, and can operate in the range of AC voltages from 200V to 800V.

The rectifier consists of four discrete Silicon diodes that are connected in a ‘bridge’ configuration. When alternating current is applied to the two input pins, it causes the diodes to act as switch and alternately allow current through in both directions, creating a pulsing output of direct current. This bridge rectification circuit is extremely useful in a variety of applications, and is commonly used in AC-DC rectification with minimal losses.

The device is most commonly used in AC-DC applications, such as AC motor control, battery charging, and power supply units. By allowing the AC voltage to be rectified to a steady and consistent DC output, the device enables smooth and accurate control of the AC motor. The rectifier is also ideal for applications where peak loads or surges of current are needed, as it is capable of delivering up to 20A of peak forward surge current (I_FSM).

The V10P20-M3/87A is also commonly used in DC-DC applications, such as voltage step-up or step-down. The rectifier can be used to convert the pulsing direct current output of the bridge rectifier circuit into a steady and consistent output voltage, either higher or lower than the input voltage, depending on the required application. The device also has a wide operating temperature range, allowing it to perform reliably in a variety of environments.

The device also has several protective features, making it a safe and reliable solution for most applications. It has an internal thermal protection circuit that will shut down the device if the temperature exceeds a certain level, and it is also equipped with reverse-polarity protection and a built-in fuse that will protect the device from over-current and shorts.

The V10P20-M3/87A rectifier is a reliable and efficient solution for applications requiring AC-DC rectification. With its wide operating voltage range, high surge capability, and built-in protection features, it is well-suited for a variety of applications that require smooth, accurate control of AC motor inputs. Additionally, the device’s ability to be used in DC-DC applications makes it a versatile and useful component in any electronics system.

The specific data is subject to PDF, and the above content is for reference