MAX14980ETO+

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The MAX14980ETO+ signal buffer chip is a multi-channel signal buffer device with an open drain (open collector) output type. It is designed to interface with voltage and current sources, as well as other data lines within a wide operating temperature range of -40 °C to +125 °C. The signal buffer is designed for applications such as digital-to-analog signal conversion, signal isolation, signal buffering, multi-channel signal buffering and signal routing.

The MAX14980ETO+ signal buffer chip has two input channels, a common output enable (OE) pin, and an enable pin that is connected to the enable pin of the input driver device. This enable pin acts as an over-current protection circuit and helps to protect the signal buffer chip by disabling the input driver device when an over-current condition is detected. The MAX14980ETO+ signal buffer chip also provides a low power output enable (LPEOE) input pin, which can be used to enable or disable the output of the signal buffer.

The MAX14980ETO+ signal buffer chip uses two sets of the same input signals, one from each of the two input channels, to create two distinct outputs. The outputs can be used either to directly drive a device or to indirectly drive another device by acting as a buffer or repeater. When the OE pin is enabled, the input signals are sent to both outputs, allowing for multi-channel buffering. When the OE pin is disabled, only one output is enabled, allowing for signal isolation and buffering.

The MAX14980ETO+ signal buffer chip also has an external 3.3V voltage regulator on-board, allowing it to operate under varying input voltage conditions. The external 3.3V voltage regulator also allows the signal buffer chip to be used in applications that require a separate ground connection, such as in industrial automation, automotive and medical applications. In addition, the MAX14980ETO+ signal buffer chip is also available with an optional internal pull-up on the OE pin, which can be used to provide an extra level of protection from over-current conditions.

The MAX14980ETO+ signal buffer chip provides high speed buffering for a wide range of applications, and is specifically designed for use in systems that require low power, low latency, high isolation, and high speed. It can be used for data isolation, signal buffering and splitting, low speed signal routing, and in multi-channel applications. The MAX14980ETO+ signal buffer chip is a cost effective solution for applications that require high speed buffering and isolation.

The specific data is subject to PDF, and the above content is for reference