APT1222WAY

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Optoisolators with Triac, SCR outputs are widely used in various applications. The APT1222WAY is an optoisolator featuring an isolated Triac with a maximum load current of 6A and a turn-on time of 10µs. It is designed to drive Triac or SCR outputs with isolated high current in the load circuit. This device is well suited for use in a wide variety of applications such as solid state switching, current sensing, and control functions. It is also suitable for interfacing analog controls to digital input/output devices.

The APT1222WAY optoisolator features an integrated Triac which provides isolation with a maximum rating of 2.5kVrms/50Hz for 1 minute. The device consists of a high efficiency deep-UV LED and an integrated photo Triac with a trigger voltage of 600V. The LED has a minimum operating current of 3mA, which allows the device to be driven directly from a wide range of logic levels, including TTL, 8051, PIC microcontrollers, and other digital systems. The output of the optoisolator is a Triac which switches high load current upon receiving a digital signal from the LED.

The optoisolator is capable of driving a variety of Triac or SCR outputs with a maximum current of 6A. The device has a minimum turn-on time of 10µs and an off-state leakage current of 1mA. The device is also designed to meet the IEC 60950-1 safety standards for electronic equipment.

In most applications, the optoisolator is configured as shown in the figure below. The input of the optoisolator is driven by a logic signal which is coupled to the LED, while the output is tapped by two output terminals. When a logic signal is applied to the LED, the current is increased to the correct level to drive theTriac, which then supplies the necessary current to the load.

The working principle of the device is fairly straightforward and can be explained as follows. When a logic signal is applied to the LED, the current is increased to the nominal level, which then drives the integrated photo Triac. The Triac then supplies the necessary current to the load, allowing it to be switched on and off according to the logic signal applied. The device is designed to ensure that no portion of the load current passes through the LED, providing a high level of isolation between the input and output.

The APT1222WAY optoisolator is therefore a very useful device for a wide variety of applications. It is durable, reliable, and provides a high level of protection for sensitive electronics against electric shock. Moreover, it is easy to configure and provides an interface between analog and digital systems.

The specific data is subject to PDF, and the above content is for reference