APT1231SX

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Optoisolators - Triac, SCR Output are electrical components that isolate both electrical and optical signals. APT1231SX is a variant of optoisolator with triac & SCR output that can provide four different levels of load current ranging from 0.5A to 4A at peak. It can be used in a variety of applications such as lighting, HVAC, energy metering, motor control particularly for Appliances, AV Appliances, Automotive, Industrial, Power Management, and Test & Measurement.The main principle of this optoisolator is to use an infrared LED to transmit a signal to a photo-sensitive silicon control rectifier (SCR) or triacs. The optoisolator acts like a switch that can turn on and off an electrical circuit with a low frequency voltage from a control module. When the LED is on, it illuminates the internal SCR or triac that then functions like an electrical switch and completes the circuit. The optoisolator can also act as a gate signal amplifier to gate circuit-breaker circuits.

The low frequency voltage from the control module is able to switch on and off the LED. This LED will increase the flow of current through the internal SCR or triac. The LED and the outside control module circuit both have two pins, one for control voltage and another for ground. The control voltage should not be higher than a certain voltage as it can cause the current to exceed the maximum switching current capacity of the LED.

The APT1231SX has several features that make it suitable for many applications. It has a narrow hysteresis that makes it easy to control the triac and it has a high peak current rating of 4A. It also has a fast switching response time of 0.5-150μs, low on resistance of 45mΩ, and can withstand up to 8A of surge current. It has a 15V reverse voltage transfer ratio of 75%, and can operate in temperatures ranging from -40⁰C to 110⁰C.

APT1231SX is an easy to use, and can provide high immunity to noise from motor back EMF, thus reducing false switching. It is also easy to replace the high power triac or SCR outputs with APT1231SX with just a few simple modifications. The major benefit of switching with optoisolators is that they can provide electrical isolation between the electronic controller and the controlled circuit. This provides an extra layer of protection for both circuits, and prevents noise from getting into the system.

The APT1231SX is a versatile optoisolator with triac and SCR output, that can be used in a variety of applications. It has a high peak current rating, fast switching response time, and low on resistance. It also provides good immunity to noise from motor back EMF, and can provide electrical isolation between the control module and the controlled circuit. With its wide range of features, APT1231SX can be a suitable choice for many applications.

The specific data is subject to PDF, and the above content is for reference