BC338-16 A1G

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

BC338-16 A1G is a type of single bipolar junction transistor (BJT) and is widely used in the majority of digital and analog circuits. The device itself is a general-purpose NPN transistor. Its most common application is within power circuits, because of its comparatively high Power Dissipation, Collector Current and low Collector-Emitter Saturation Voltage.

In specific, the power dissipation of this particular transistor is 200 Watts, its Collector Current is 2 Amps, and its Collector-Emitter Saturation Voltage is 0.50 Volts. Furthermore, the maximum DC Current Gain of BC338-16 A1G is the average of 200, and the various Junctions are all SPC (Silicon NPN Planar Collector).

The working principle of the BC338-16 A1G transistor is relatively simple. It is a three-terminal device, consisting of a base, collector and emitter terminal. Typically, these three terminals are separated by PN junctions for the collector and an NPN junction for the base. Essentially, a small current enters the base terminal, which is then amplified and released from the collector terminal in a much higher current, while the emitter terminal releases the remaining current.

More simply, the base-collector junction acts like a switch, allowing current to flow through the transistor when voltage is applied between the base and the emitter. Therefore, when a small current enters the base, it is amplified in the collector end and is released from the collector terminal. The BC338-16 A1G is used for switching purposes in both digital and analog circuits, allowing for voltage and current amplifications.

The BC338-16 A1G can also be used for signal amplifying. It is important to note, however, that the signal amplifier will depend upon a range of factors, such as the amount of available power, the environment, and the circuit application. Hence, the signal amplifying ranges may be dependent on the specific requirement of the circuit.

In the majority of circuit applications, the BC338-16 A1G transistor is capable of switching up to 2 Amps of current with high efficiency and low minimum saturation voltage. Additionally, due to its significant power dissipation and low cut-off voltage, it is a popular choice for power supplies, especially when currents at low voltages are expected. The low saturation voltage enables it to offset its over current with ease and also limits any further power losses.

In short, the BC338-16 A1G transistor is a single-junction bipolar junction transistor (BJT), utilizing NPN junctions for collector and base. Its typical application is in power circuits, due to its comparatively high Power Dissipation, Collector Current, and low Collector-Emitter Saturation Voltage. It is most commonly used for switching and signal amplifying purposes, due to its high efficiency and low minimum saturation voltage, however this will depend on the specific circuit requirements.

The specific data is subject to PDF, and the above content is for reference