2N6308

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

2N6308 is a PNP general-purpose transistor commonly used in a variety of applications. It is one of the most commonly used transistors in the world and is widely used to amplify signals and switch loads. This article serves as an introduction to the 2N6308 PNP Transistor and will offer some information on its application field, working principle and characteristics.

Application Field

2N6308 are mainly used in the amplification and switching applications. These transistors can be used in many different circuits to build different electronic products such as AM and FM radios, digital clocks, amplifier circuits and many more. These transistors are also used in switching applications such as motor control, light dimming and solenoid control. These transistors can also be used in solar cell applications due to their high current gain and low base-emitter voltage.

They are also suitable for a variety of other applications such as high frequency switching, high-speed switching, power switching and interface circuits. Furthermore, 2N6308 can also be found in applications like audio pre-amplification, analog signal processing, active filters and oscillators.

Working Principle

2N6308 is a PNP transistor that uses three pins. There are two separate VCCs, a positive one and a negative one. The positive is connected to the collector, the negative is connected to the emitter and the base is connected between the two VCCs. When the base voltage is higher than the collector voltage, then a current will flow through the transistor from the collector to the emitter. This current flow is the current gain and is expressed in terms of the current transfer ratio (CTR).

When the base voltage is lower than the collector voltage, then a current will flow from the emitter to the collector. This current flow is referred to as the reverse current gain and is represented by the reverse current transfer ratio (RCTR). CTR and RCTR are useful parameters when designing circuits with the 2N6308 PNP transistor.

Characteristics

The 2N6308 has a current gain of 300 to 500. It can withstand a maximum of 150V DC and has two outputs. It has an operating voltage range of 0-30 volts and a maximum collector-emitter voltage of 30V. The maximum collector current is 5 Amperes and the maximum collector power dissipation is 30W. The transistor has a valley current at which it can switch from conducting to non-conducting state and vice versa. This valley current is 0.7V for the 2N6308.

The 2N6308 also has a maximum frequency of amplification or cut-off frequency of 300MHz. It also has a high input impedance and a low output impedance. These features make it suitable for high frequency switching and amplification applications.

In conclusion, the 2N6308 PNP transistor is a widely used general-purpose transistor for amplification and switching applications. It has a high current gain and a valley current of 0.7V. It can be used in a variety of applications such as audio pre-amplification, analog signal processing, active filters and oscillators.

The specific data is subject to PDF, and the above content is for reference