JANS2N5004

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The JANS2N5004 is a general-purpose bipolar NPN silicon transistor commonly used for switching and amplifier applications. The device has a collector-emitter voltage of 60V and a collector-base voltage of 60V, a maximum continuous collector current of 800mA and a maximum power dissipation of 400mW. It has a current gain of around 100. The JANS2N5004 is widely used in low-frequency and audio amplifiers, relay drivers, oscillators and small DC motors.

The working principle of the JANS2N5004 is based on the NPN transistor. It starts by connecting the emitter of the transistor to ground or negative bias, the collector to a voltage source and the base to a current source. Electrons in the base region are attracted towards the higher voltage at the collector and are then collected by the collector terminal. This generates a current in the collector, proportional to the base current.

In a typical application, the JANS2N5004 is used as a switch. It is connected in series with the load, allowing current to flow through the device when it is switched on. The voltage at the base determines the amount of current flowing through the device, and consequently the amount of current drawn from the power source. By controlling the base current, the transistor can be used to control the amount of current into the load, thus allowing for precise current control.

The JANS2N5004 is also used as an amplifier. In this application, the transistor is connected in common-emitter configuration, with the emitter connected to ground and the collector connected to a voltage source. The output is taken from the collector, while the input is applied to the base. The transistor amplifies the input signal, carrying out voltage or current gain depending on the circuit in which it is used.

The JANS2N5004 is a general-purpose NPN silicon transistor widely used in a variety of applications in low-frequency and audio amplifiers, relay drivers, oscillators, and small DC motors. It has a collector-emitter voltage of 60V and a collector-base voltage of 60V, a maximum continuous collector current of 800mA and a maximum power dissipation of 400mW. It has a current gain of around 100. This device is mainly used to switch signals and as an amplifier in common-emitter configuration.

The specific data is subject to PDF, and the above content is for reference