SI4825-A10-CS

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

RF receivers are among the most integral components of any wireless communication system. The SI4825-A10-CS is an example of such a receiver in the form of a low-power, cross-band, digital FM radio receiver. This device has both AM and FM receiver capabilities, making it a perfect candidate for use in consumer electronic products such as car stereos and cellular phones.

The SI4825-A10-CS is based on a low-power monolithic SiGe (silicon-Germanium) process technology which enables it to operate at low-voltage levels (1.8 to 3.6 V), low power consumption, and excellent RF performance. It covers all continental European frequencies for AM and FM reception. It has an onboard low-noise amplifier, disable switch, mute control, RF port, and audio port as its principle components.

This device is designed with two sets of pins for connection. One set is for communication for inter-chip communication and control, the other is for analog signal connections. The communication interface uses the bi-directional 2-wire protocol (I2C) for communication with host systems, while the analog signals consist of a UHF antenna input, an FM antenna input, a Volume Control (VC) signal, and an external DC bias voltage.

The primary purpose of the SI4825-A10-CS is to receive FM/AM radio signals, process them, and output them as analog audio signals for playback in external speakers. The device employs a direct-conversion architecture, which consists of two identical quad-mixing blocks with independent and programmable phase-locked-loops (PLL). The two output signals from the quad-mixer then proceed to an on-chip demodulator to produce a baseband signal. This is then further amplified by a low-noise pre-amplifier, and converted to a digital signal for processing in the on-chip digital signal processor (DSP).

The DSP then uses the programmable coefficients stored in an on-chip RAM to digitally demodulate the signal and generate a stereo output. This stereo output is then sent to the audio output port, where it is further amplified and sent to a loudspeaker or other listening device. Additionally, the device uses a low-power, narrow-band double-tuned-IF filter for improved reception and greater spectral selectivity, as well as a digital AGC to maintain a constant signal level.

Given its flexible design and low-power consumption, the SI4825-A10-CS has a wide range of applications, including automotive audio systems, mobile phones, and portable media players. In these applications the device is used to receive audio signals from local radio stations, and then process and output them as easily-listenable audio signals. With its excellent sensitivity, selectivity, and distortion, the SI4825-A10-CS is an excellent choice for any consumer electronics product requiring good-quality sound.

The specific data is subject to PDF, and the above content is for reference